 |
After printing,
use a copy machine to enlarge image until line measurements are
equal to measurements listed above. Template diagram also available
in PDF file format. |
For 1 block cut the following:
Cream background square ...
One 13 1/2" square (trimmed to 12 1/2" after Template A pieces
have been appliquéd in place)
|
Template A:
... Green ... 8
... Light purple... 8
... Dark purple ... 4
|
In addition to fabric required for the block, you will
need lightweight fusible interfacing.
ASSEMBLY INSTRUCTIONS
FUSIBLE APPLIQUÉ METHOD
(If fusible appliqué is not desired, use technique of choice
to appliqué pieces in place.)
Step 1. Using a fine line permanent
pen, trace Template A onto smooth side of fusible interfacing (rough
side is the fusible side). Cut out interfacing section of "bead"
approximately 1/2" from line. Place interfacing drawing on appropriate
fabric with fusible side against right side of fabric. The smooth
side of interfacing is on top. Pin in center of Template A piece.
Do not press with iron.
Step 2. Using an open toe sewing
machine foot, and a short straight stitch length, sew slightly to
the outside of interfacing drawn "solid" line. (If sewn directly on
the line, the finished piece will be smaller than required. Sewing
slightly to the outside of the drawn line allows room for turning
the fabric right side out. See Diagram I) Trim each piece to scant
1/4" beyond sewn line. Clip curves.
